3" Horizontal Stainless Steel Z-Vent wall-hung water heater vent kit for Eccotemp i12-NG, Eccotemp i12-LP, Eccotemp FVI12-NG, Eccotemp FVI12-LP, 20HI-LP and 20HI-NG, 40HI-LP and 40HI-NG models. It also works for Paloma/Rheem models: RTG-53, RTG-42, PH-1, PH-20, PTG-42, and many of the Bosch tankless water heaters that use 3" diameter stainless steel venting.
(1) 3" Universal Appliance Adapter (UAA)
(1) 3" x 1.5' pipe
(1) 3" x 1' pipe
(1) 3" x 90 degree elbow
(1) 3" Wall thimble
(1) 3" Termination Hood with backflow preventer
If using this kit with an Eccotemp heater that has a 2.5" diameter flue opening (such as the FVI12 or i12), then the 2.5" to 3" Vent Adapter, found in the Related Gadgets tab below, is required.
Your installation may require additional pieces. Please contact us for assistance, or browse the Single Wall Venting category here on GadgetsGo.com.
For example, this kit does not include a condensate drain pipe which may be required depending on your water heater manual guidelines and building code. This vent part with only the condensate drain can be connected to the UAA in this kit.
• Vent material: AL29-4C stainless steel, made in USA
• Certification: Tested to meet or exceed Underwriters Laboratories (UL) spec UL1738 and ULS636
• Approval: Cat II, III, IV venting
• Limited Lifetime Warranty
Z-Vent SVE Series IV Installation and Maintenance Instructions, 3" to 24", Single & Double Wall
Z-Vent Dimensional Specifications